![kiwix raspberry pi kiwix raspberry pi](https://community.element14.com/resized-image/__size/320x180/__key/communityserver-wikis-components-files/00-00-00-01-69/5875.contentimage_5F00_196405.png)
Start the hostapd and dnsmasq services by: sudo service hostapd startĨ. Search for the following line and uncomment it: #_forward=1 Which looks similar to the following line: DAEMON_CONF="/etc/hostapd/nf"įorwarding is necessary if any devices connected to your access point needs to connect to the internet. In this file go to the line #DAEMON_CONF=” ”, uncomment it by deleting the # before it and enter your path in between the quotes. Now we need to link this hostapd file as a default: sudo nano /etc/default/hostapd Ssid is the host name which will broadcast to the other devices and wpa_passphrase is the password.You need to change these to your preference. Type the following commands in the new file: interface=wlan0
#Kiwix raspberry pi software
You need to configure the host software package, to do that: sudo nano /etc/hostapd/nfĪ new file will be created.
![kiwix raspberry pi kiwix raspberry pi](http://travelinlibrarian.info/wp-content/uploads/2013/05/Calibre-Web.png)
Hence, we will rename the existing file and create a new one, so that dnsmasq will use this file: sudo mv /etc/nf /etc/ Now, restart the DHCP service by: sudo service dhcpcd restartĭnsmasq's default configuration contains lots of information which is not being used here. Then add these lines at the end of the file and save it- interface wlan0 Dnsmasq acts as both a DHCP and DNS server so that the user can assign IP addresses and it can process the requests of DNS through Raspberry pi itself, and also it becomes easy to configure.ģ. Adding a static IP for the access pointĪssuming that the standard 192.168.#.# IP is being used for networking we are going to set up the WiFi IP to 192.168.0.1 by editing the DHCP configuration file: sudo nano /etc/nf Hostapd is the one which allows the user to use the WiFi as an access point or as a hotspot. Stop these services temporarily for doing a couple of other changes by: sudo systemctl stop dnsmasq
#Kiwix raspberry pi install
Now, let us install our two software packages i.e hostapd and dnsmasq : sudo apt-get install hostapd
#Kiwix raspberry pi update
Update and Upgrade Before moving to installing and setting up the packages, you'll have to update and perform an upgrade on pi by entering the following commands: sudo apt-get update Plug everything in and get into the terminal.ġ. Very basic knowledge of Linux and Networking would be useful (but not mandatory) since we're going to get into the command line here. Setting up your Raspberry Pi as a wireless access point if you get a different result, search online for it and see if it is supported. We found out that this dongle doesn't support AP mode by default. To do this, open up the terminal with the dongle plugged in and type: lsusb
![kiwix raspberry pi kiwix raspberry pi](https://i.snap.as/GTWfXzq4.jpg)
If you have a Raspberry Pi 3, then just skip to the next heading but if you are using an older version of the Pi along with a USB WiFi dongle, you need to make sure that it supports WiFi Access point.